Connecting MUX with an electronic circuit

I would like to connect the output of curtain parts of my circuit to a MUX, the circuit consists of an AC supply and resistors and i cant seem to connect the MUX with any part of the circuit. For example the circuit i attached, assuming that the wires connected to the oscilloscope is connected to an MUX instead.

Answer 1

[Walter Roberson]

There are some processes that are usable for electrical circuits that appear in three different ways:

1. Raw Simulink
2. Simscape Electrical
3. Simscape Electrical Specialized Power System

The two Simcape Electral implementations are both Simcape / Simevents based, but they are optimized for different purposes. There are conversion blocks between the two, but it is better (more efficient) if you do not mix them.

The raw Simulink implementation is incompatible with the Simscape based implementations, and as far as I recall there are no conversion blocks.

So, you should go back to your blocks and check which library they are in and try to find equivalents from the library you want to use.

Sometimes the answer is not obvious. For example if I recall correctly, resistors appear directly in two of the three libraries, but in the third one, you are expected to use an RLC block .