ArduinoIO package and Arduino Uno Motor Shield R3 server sketch?

I'm trying to use R3 shield with matlab script. I installed the ArduinoIO package but there is no server sketch for Arduino software for this particular shield. Only Adafruit motor shields are included. Where do I get the right sketch for driving R3 with this package?

Answer 1

[Sami Harju]

I figured this out. No sketch was needed, just the right tools. Arduino can read serial ports and matlab write to them. Here's the codes if anybody ever meets the same "problem":

Arduino:

// using example:
// http://social.nkcelectronics.com/discussion/1/arduino-motor-shield-r3-introduction/p1

// Include the Stepper Library
#include <Stepper.h>

// Map our pins to constants to make things easier to keep track of
const int pwmA = 3;
const int pwmB = 11;
const int dirA = 12;
const int dirB = 13;

// The amount of steps for a full revolution of your motor.
const int stepsPerRevolution = 200;

// Initialize the Stepper class
Stepper myStepper(stepsPerRevolution, 12,13);     

// Initialize the incoming command byte
char incomingByte = 0;

void setup() {
   // Set the RPM of the motor
   myStepper.setSpeed(40);

     // Turn on pulse width modulation
     pinMode(pwmA, OUTPUT);
     pinMode(pwmB, OUTPUT);
     digitalWrite(pwmA, HIGH);
     digitalWrite(pwmB, HIGH);

     // Start the log
     Serial.begin(9600);
    }

void loop() {
        // Wait for any input from serial
        if (Serial.available() > 0) {
          // Read the incoming byte
          incomingByte = Serial.read();

            // Commands for stepper
            if ( incomingByte == 'a' ) {
              myStepper.step(200);
            }  
          }
        }

Matlab:

% using example:
% http://se.mathworks.com/help/instrument/writing-and-reading-data-2.html
pause on;

% initialise serial object
s = serial('COM6');
s.Baudrate=9600;
s.StopBits=1;
s.Terminator='LF';
s.Parity='none';
s.FlowControl='none';

% open for usage, pause for process delay
fopen(s);
pause(2);

% give the serial port a command for arduino to execute
for n = 1:10
    fprintf(s,'%c','a'); % using char a for "drive"
    pause(2);
end

delete(s)

[Guilaume lollia]

it is probably what i am looking for i have been trying to make a GUI with matlab 3 GUI- pushbutton making my stepper motor 3 differents angle, 60, 45, 75 degrees with Arduino Motorshield Rev3

As i am a complete beginner with this arduino and communication devices.

and then i do not understand your statement using char a for "drive". Could you explain me please ?

what will be line code or will you write to make it move ?

Thanks