Community Profile

photo

Ian


Active since 2014

Followers: 0   Following: 0

Message

Statistics

  • Thankful Level 1

View badges

Feeds

View by

Answered
Selective plotting from .csv file
Hi Michael, Thanks again for the code. Is it possible to use this code in the form of a GUI. I made a small gui using GUIDE, bu...

9 years ago | 0

Answered
Selective plotting from .csv file
Hi Michael, No the design number is not equal to the length. Actually there are more parameters (around 20) to select each de...

9 years ago | 0

Question


Selective plotting from .csv file
Hi, I've 2 sets of results from another software. Say Design1 and Design2. In each Design I've a set of X and Y values to plo...

9 years ago | 3 answers | 0

3

answers

Question


Combine all Output Graphs
Hi, I have output graphs "Torque over time" from 3 revolute joints in Simmechanics. Is it possible to combine all these graph...

10 years ago | 0 answers | 0

0

answers

Answered
Contact Simulation in SimMechanics
Hi Tony, I have attched an example file. You can see the Rod passing through the wall. I tried using Rotational hardstop. Now th...

10 years ago | 0

Question


Contact Simulation in SimMechanics
Hi, Is Contact simulation possible in Simmechanics 2nd gen?? I tried to understand the double wishbone suspension and i quite...

10 years ago | 4 answers | 0

4

answers

Question


Torque and Motion actuation
Hi, Why is that I'm not getting any torque, when i actuate a revolute joint through Motion. I rotated a body from 0 to 30 deg...

10 years ago | 0 answers | 0

0

answers

Question


Rotate - Stop - Rotate again
Hello, Is it possible to actuate a revolute joint, revolve for 3s and stop for 2s and then again start revolving? How sho...

10 years ago | 0 answers | 0

0

answers

Question


Controlling an Input signal?
Hi, Is it possible to control an Input signal with respect to time. I have actuated a revolute joint through torque. The tota...

10 years ago | 1 answer | 0

1

answer

Question


Is it possible to add more Input's to a Joint in SimMechanics?
Hallo, I'm simulating using Simmechanics 2nd generation. I want to rotate an object say for 2 sec and then Stop and rotate ag...

10 years ago | 0 answers | 0

0

answers

Question


Conditional linking between 2 parts - Simulink/ SimMechanics
Hi, Is it possible to connect two parts in SimMechanics prescribing some conditions. Like I have two indivdual rotating parts...

10 years ago | 0 answers | 0

0

answers

Question


Motion control in SimMechanics 2nd generation!!
Hi, I am using a revolute joint between two bodies. Is it possible to control the revolution, like say it should rotate only ...

10 years ago | 0 answers | 0

0

answers

Question


Simulating an assembly in SimMechanics 2nd Generation
Hi, I have successfully translated an assembly from Pro-E to SimMechanics ( *2nd Generation* ). Its quite a huge component wi...

10 years ago | 0 answers | 0

0

answers