Community Profile

photo

James Robertson


University of Bath

Active since 2011

Statistics

  • Thankful Level 1
  • Revival Level 1
  • First Answer

View badges

Content Feed

View by

Answered
fuel cell design, out of memory
I had a similar problem which occurred at the same time in each run despite there being plenty of available RAM (according to Ta...

11 years ago | 0

Answered
Out of memory
I had a similar problem which occurred at the same time in each run despite there being plenty of available RAM (according to Ta...

11 years ago | 0

Question


Error "Creation of 16MB StandAlone applications not supported" - Why?
The following error is generated by xPC Target embedded and no embedded code folder is generated if I select a 16MB ‘Maximum Tot...

12 years ago | 0 answers | 0

0

answers

Question


XPC Target Embedded Filescope Dynamic File Naming
I’m having trouble with the dynamic file naming of Filescope Blocks in xPC Embedded Option. I would like the file name of a scop...

12 years ago | 1 answer | 0

1

answer

Answered
Using More Than 4 Analog Inputs Causes Software Created with xPC Target Embedded Option to Not Run
Walter: Yes I had tried skipping out each channel but no joy. An update for anyone else who comes across this problem.... ...

12 years ago | 0

Question


Using More Than 4 Analog Inputs Causes Software Created with xPC Target Embedded Option to Not Run
I am using xPC Target Embedded Option (2010b) with a NI PCI-6229 I/O card as a controller and data logger for hydraulic systems ...

12 years ago | 1 answer | 0

1

answer

Answered
Why digital outputs of NI PCI-6229 card never change in xPC?
I am able to use the digital outputs on my NI PCI-6229 with xPC Target Embedded Option (ver 2010b) without the above problem. I ...

12 years ago | 0