How do I configure a GPIO pin as an external interrupt in a Target Support Package?
4 views (last 30 days)
Show older comments
I would like to configure GPIO pin as external interrupt for F28335 board. I would like an example or demo for this.
Accepted Answer
MathWorks Support Team
on 17 Jan 2013
The attached model configures GPIO0 as external interrupt to trigger the blinking of LED. The custom code in the System Initialize block assigns GPIO0 as an input to trigger the XINT1 interrupt:
EALLOW;
GpioCtrlRegs.GPAMUX1.bit.GPIO0 = 0;
GpioIntRegs.GPIOXINT1SEL.bit.GPIOSEL = 0;
EDIS;
XIntruptRegs.XINT1CR.bit.ENABLE = 1;
XIntruptRegs.XINT1CR.bit.POLARITY = 1;
The ISR toggles the LED based on a rising edge of GPIO00. Connect GPIO to 3V and GND in order to blink the LED.
0 Comments
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!