Why do I receive the warning "No blocks found for looping" when generating a Simulink Report for a model with a Masked Subsystem?
1 view (last 30 days)
Show older comments
Why do I receive the warning "No blocks found for looping" when generating a Simulink Report for a model with a Masked Subsystem?
When running the report generator you see the following warning in the Generation Status panel of the Setup File Editor:
no Blocks found for looping
If you look at the HTML document in Table-1-6, the blocks from the Masked Subsystem appear correctly. Its interesting though that Table 1-6 lists the blocks in this masked subsystem yet this warning should occur.
Accepted Answer
MathWorks Support Team
on 27 Jun 2009
This bug has been fixed for Release 14 (R14). For previous releases, please read below for any possible workarounds:
This warning is just an informational message. It means that the system doesn't contain any blocks for the block loop to loop upon. The warning message has no effect on the behavior of the Simulink Report Generator.
0 Comments
More Answers (0)
See Also
Categories
Find more on Subsystems in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!