Question about the "enable" block.
1 view (last 30 days)
Show older comments
Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?
0 Comments
Accepted Answer
More Answers (2)
Arnaud Miege
on 18 Mar 2011
Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud
0 Comments
Sébastien Malengé
on 18 Mar 2011
2 Comments
Guy Rouleau
on 22 Mar 2011
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
on 23 Mar 2011
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.
See Also
Categories
Find more on Schedule Model Components in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!