Is possible catia to simmechanics link..?
4 views (last 30 days)
Show older comments
Hi :
I know Matlab simmechanics link only support Pro/E & solidworks.
But I usually use catia to set assembly kinematics(revolute joint, prismatic joint...etc).
as the follow picture
So.... Can I
1. Can I use Catia to simmechanics link, and how
2. If 1 is not, Can I transfer catia file to pro/e or solidworks file which can use simmechanics link, and how
thanks
0 Comments
Accepted Answer
Friedrich
on 14 Dec 2011
Hi,
1.) I doubt you can this. Like you found out, Simmechanics Link support Pro/E and solidworks only
2.) There are converter available which can convert files between Catia and e.g. Pro/E:
Unfortunately there isn't much available from the MATLAB / Simulink side to interact with CATIA. The only way I am aware of is to use the COM interface from CATIA to communicate with it from MATLAB. There was a post here on MATLAB Answers:
In addition, the same question you have is already answered here:
2 Comments
Friedrich
on 15 Dec 2011
Sorry I am not a Catia expert. I think the question would be better for a CATIA forum instead of a MATLAB forum.
More Answers (0)
See Also
Categories
Find more on Simscape Multibody in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!