How to do noise analysis of input signal?

2 views (last 30 days)
Sneha
Sneha on 21 Aug 2014
Commented: Life is Wonderful on 11 Mar 2020
hey, i need to do noise analysis(mainly for flicker noise) of input signal which contains noise. i don't understand analysis means exactly what i need to do? which parameters should be analyse and how?? and also i need to separate the detected or analysed noises. how to proceed??

Answers (2)

Iain
Iain on 21 Aug 2014
You should figure out "what flicker noise means" - I would take (temporal) noise to be the RMS variation from the expected value of the signal. But that's not just flicker noise....

Image Analyst
Image Analyst on 21 Aug 2014
For flicker noise, like in a video where some frames are brighter or darker than the prior or subsequent frames, you can take the difference between a frame and the average of its neighboring frames. If the difference is small (a number you decide upon that is "normal") then there is no flicker but if the number is higher or lower then the frame is brighter or darker. You can take a histogram of differences to determine if the flicker is brighter or darker than the "good" frames, assuming the flickered frames are less than 50% of the frames.
  2 Comments
Life is Wonderful
Life is Wonderful on 2 Mar 2020
Can you please help me with flicker frame detection for the issue in the below link
Thank you!
Life is Wonderful
Life is Wonderful on 11 Mar 2020
Do you have any feedbeack here ? Or my question is not clear / I am I missing or not clear
Thank you!

Sign in to comment.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!