Error when using imshow()

1 view (last 30 days)
bazinga
bazinga on 6 Feb 2014
Commented: Walter Roberson on 10 Feb 2014
Hi,
I'm trying use imshow to display a colormap image, however I get the following error:
??? Error using ==> checkDisplayRange at 22 HIGH must be greater than LOW.
Error in ==> imageDisplayValidateParams at 57 common_args.DisplayRange = checkDisplayRange(common_args.DisplayRange,mfilename);
Error in ==> imageDisplayParseInputs at 79 common_args = imageDisplayValidateParams(common_args);
Error in ==> imshow at 199 [common_args,specific_args] = ...
What does this mean and how can I solve this problem? Any suggestions would be of help.
Thanks

Answers (1)

Walter Roberson
Walter Roberson on 6 Feb 2014
You used imshow() in the form
imshow(YourData, [LOW HIGH])
but your HIGH value was not strictly greater than your LOW value (e.g., might have been the same value or they might have been reversed.)
  2 Comments
bazinga
bazinga on 6 Feb 2014
Yes I have used that form. I have looked at the values; the maximum is 1 and minimum is 0.
Walter Roberson
Walter Roberson on 10 Feb 2014
imshow doesn't think that you passed in [0 1], but I do not know what it thinks you passed. The values passed in: what class() were they?
At the MATLAB command line, command
dbstop if error
and run again. When it stops in checkDisplayRange have a look at what values the routine things HIGH and LOW have. Then command "dbup" enough times to get to the outer level of imshow() and see the values as they were received in the routine. Then dbup again and check the values as passed.

Sign in to comment.

Categories

Find more on Display Image in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!